Two way stage shock alarm. After remote start, must turn the key to ON position and then press the brake. Remote start times are 3 mostly.
LCD remote with vibtation light audible warning. Supporting diesel or petrol car.Supporting auto or manual transmission car. Max current of the flash light output. Max current of the siren output. Max current of the central door lock. Current of the shock sensor. Product compositions: 1 main unit, 1pc start stop button, 2pcs FM LCD alarm remotes, 3 groups main cables, 1pc start module, 1pc shock sensor, 1pc LED indicator. 1pc alarm electronic siren, 1pc killer relay, 1pc reset button, 1 pc alarm antennas, 1pc english manual, 1pc color box. The main unit is suggested to placed under the panel. After fixing the main unit in a.
Suitable place, start connecting the wires in accordance to the WIRE CONNECTING DIAGRAM. Before putting back all the parts, simply test the system function first. Install the sensor after fixing the main unit. It is recommended to place the shock sensor. Near the car doors, or beside the panel so as to easily detect any intrusion actions.
Adjust the sensitivity of the shock sensor, simply use a screw to turn the button in the. Shock sensor, turning right to.Adjust with a higher sensitivity or vice verse. Then test the sensitivity by triggering the. If i t triggered, the L. Please do not directly hit the. This system can control several common central lock types without any additional parts. For cars equipped with no central lock, recommended to install it first.
For cars equipped with central lock but no motor on driver aside, add master motor and rod. This type of installation is applicable to operate factory lock system in some. FORD, Mitsubishi, Mazda, and Nissan models. Installation tips: First install the actuator near the door' s manual latch, then fix the. Rod of the actuator on the manual latch.
For cars equipped with central lock and with motor on the driver' s side. The door locks are controlled by electrical activated vacuum pump. Actuator mechanism can be set as 0.7 seconds or 3 seconds at the JP2.
For some Mercedes-benz and Audi models. For some cars not mentioned above, please consult your dealers. NOTE: Type B installation method (FIG 2) is suitable for most of the cars.
The remote control does not work. It is suggest to replacing a new battery each year. Check if the remote control is moisten or crash. The remote control does not make the main unit work.
Check the battery level in the remote control. Check if the frequency of the remote control is changed. If possible, use another control for comparison.If both of them do not work, then check. The main unit and the wire connection.
(Do not open the main unit for checking). The central lock does not work.Check if the actuators are working. Check if the fuse of the main unit is damaged. The siren does not sound when the system is triggered. Check if the sirens are available. Check the wire connection between the siren and main unit. The siren keeps chirping while the main unit installs. Check if the socket is insert converse or check the wires connection or the CPU safety. If back up battery is used, check if the switch is positioned at ON status.
The alarm sounds 10 seconds after the vehicle is armed, same problem keeps happening again. Check if the shock sensor is too sensitive.
Check if the door pin switches are damaged. The alarm is easily triggered when a heavy vehicle is passing through. The item "Remote starter 2 way car security alarm ultrasonic sensor motion alarm trigger" is in sale since Sunday, October 14, 2018. This item is in the category "Consumer Electronics\Vehicle Electronics & GPS\Car Alarms & Security\Car Alarms & Security Systems".The seller is "cathycardot" and is located in shenzhen, guangdong. This item can be shipped worldwide.