EZSDEI475 RPN 476P Keyless remote alarm starter car entry transmitter clicker

EZSDEI475 RPN 476P Keyless remote alarm starter car entry transmitter clicker
EZSDEI475 RPN 476P Keyless remote alarm starter car entry transmitter clicker

EZSDEI475 RPN 476P Keyless remote alarm starter car entry transmitter clicker

Remotes Button Graphics are faded see photo. Original keyring loop is broken off a hole has been drilled to securely hold a keyring see photo. Aftermarket remote keyless entry fob alarm. Transmitter control clicker keyfob controller replacement. Functions at 100% Tested & Guaranteed.

Frequency: 433 - 434 MHz. A Valet / Programming switch is required to program this remote. Programming can be difficult if you are not familiar with it. Please read the programming instructions (below) before purchasing.

Assistance from an auto specialty shop or locksmith may be needed. Compatible w/ the following systems. The vehicles system can store up to 4 transmitters (remotes) into memory. Use the following programming routine to add transmitters to the vehicles security system or to change button assignments if desired.

In order to enter Learn Routine, the Valet/Program push button must be plugged into the main brain's Blue 2 Pin Port (Look for a small black push button located under the drivers dash or drivers kick panel somewhere). The Valet/Program switch, plugged into the blue port, is used for programming. There is a basic sequence of steps to remember whenever programming this unit. Open a door and make sure the dome light is on. Turn the ignition on to the RUN position or you may also start car.

Within 10 seconds, press and release the Valet/Program switch the number of times that corresponds to the desired channel (listed below). Once you have selected the channel, press the switch once more and HOLD it. The LED will flash and then the horn will chirp (if connected) to confirm the selected channel.

Do not release the Valet/Program switch. Arm / Disarm / Panic. Silent Mode / Remote Valet / Trunk Release.

Remote Start or other accessories. Arm only (4 button remote). Disarm only (4 button remote). Panic only (4 button remote).

Auto Program single Arm Disarm Panic button configuration (4 button remote). If any transmitter button from a known transmitter is programmed to channel 9, all transmitters will be erased from memory. This is useful in cases when one of the customers transmitters is lost or stolen. This will erase any lost or stolen transmitters from your systems memory.

It can also be used to start from scratch if the transmitter buttons were programmed incorrectly. You can advance from programming one channel to another by releasing the Valet/Programming switch and tapping it to advance channels and then HOLDING it. For instance; you have programmed Channel 1 and you want to program Channel 2. Press it one time and release it to advance from Channel 1 to Channel 2. Now, press and HOLD the Valet/Program switch.

The LED will flash 2 times and the horn will chirp twice (if connected). As before, do not release. If you want to program Channel 3 after programming Channel 1, release the Valet/Program switch, press it twice and release it to advance to Channel 3. Then press it once more and HOLD it. The horn will chirp 3 times (if connected) and the LED will flash 3 times to confirm it is ready to receive the code from the transmitter.

Once the code(s) are learned, the Valet/Program push button can be released. Programming mode will be exited if one of the following actions occurs.

Ignition key is turned to the OFF position. Valet/Program switch is pressed too many times. More than 15 seconds elapses between programming steps.

The horn will emit one long chirp when programming mode has been exited. Due to scams etc, we DO NOT respond to emails. Messages & Best Offers are checked throughout the day & we typically respond 7 days a week. The item "EZSDEI475 RPN 476P Keyless remote alarm starter car entry transmitter clicker" is in sale since Monday, December 16, 2019. This item is in the category "eBay Motors\Parts & Accessories\In-Car Technology, GPS & Security\Dash Cams, Alarms & Security\Remote Entry System Kits".

autoparts" and is located in Wellsboro, Pennsylvania. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Antigua and barbuda, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Saint lucia, Montserrat, Turks and caicos islands, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Pakistan, Paraguay, Reunion, Russian federation.
EZSDEI475 RPN 476P Keyless remote alarm starter car entry transmitter clicker